REME HALO Installation Manual and Wiring Diagram For Contractors

REME HALO UV Light Air Purifier Model REME-H-24 Wiring Diagram 

IMPORTANT NOTICE: RGF recommends for  Optimal Performance and Maximum Cell life product operates continuously. Cycling a Mercury UV bulb on and off can shorten the useful life of the bulb.  

NEED BETTER PRICING on REME HALO or LED? Contractors Call 910-401-3910

Buy REME HALO UV light air purifier H-24 for sale

 

Below is the wiring color code for 120 Volt, 208 Volt and 240 Volt.

Wiring Color Code REME HALO H-24

REME HALO Installation Manual

Installation manual for the REME HALO H-24 

Special Installation Instructions for the REME HALO LED

Contact us to BUY LED NOW in stock now 10-16-20

For more information on REME-H Model Check out REME HALO FAQ's

NEED HVAC PARTS?  Find YOUR PART HERE!

REME HALO Size and Dimensions

The REME HALO is approximately 13.8 inches long with an approximately 11 inch insertion. The Base Height is approximately 7.4 inches and the base width is approximately 6.5 inches wide. The tip of the insert is approximately 3 inches in diameter.

REME HALO MODEL REME-H Dimensions

REME HALO Data Sheet

Model # REME-H
Technology REME®
Recommended Cell Replacement 18,000 – 25,000 hrs.
Replacement Cell Part # PHIC-RH
Power Supply 110 VAC 60 Hz
Volts 24 VAC
Amps 0.7 A
Watts 17 W
Tonnage 2.5 – 16.25
CFM’s 1,000 – 6,500
Installation In Duct
Material Aluminum / polymers
Dimensions See drawing below
Ship Weight 6 lbs.
Hydro-Peroxides <.02 PPM

 

Recommended Use with Electro Static Filters

The Manufacture recommend using the REME HALO with Electrostatic filters for best results. Atomic Filters MERV 11 and MERV 13 are both high quality electrostatic filters manufactured in the USA.

See MERV 11 AC/Furnace Filters by size   

See MERV 13 AC/Furnace Filters by size 

Find more information about the REME HALO

REME HALO LED for Home Air Purification 

Get on the list to be notified when REME HALO is back in stock. 

See a comparison between the REME HALO and the REME HALO LED

Back to blog

1 comment

After installing how will I know the light is working?

Verna Shanstrom

Leave a comment

Please note, comments need to be approved before they are published.